• MAP-ECU Man's Avatar
    5th-September-2019, 04:31 PM
    MAP-ECU Man replied to a thread Fuel Cut question in Technical
    You have to wire 2 wires. The OEM MAP sensor output is connected to a spare MAPECU3 analog input configured to "FCD1" and then you configure a...
    5 replies | 81 view(s)
  • MAP-ECU Man's Avatar
    2nd-September-2019, 10:28 AM
    You can edit the pressure scale file MAP_CONFIG.cfg if you really want to but we might need to provide advice on the layout. Thanks for the link...
    3 replies | 63 view(s)
  • MAP-ECU Man's Avatar
    2nd-September-2019, 10:16 AM
    MAP-ECU Man replied to a thread injector sizing in Technical
    1650cc injectors still feel more than double plus the the additional required for E85?
    5 replies | 89 view(s)
  • MAP-ECU Man's Avatar
    2nd-September-2019, 10:14 AM
    MAP-ECU Man replied to a thread Fuel Cut question in Technical
    Ok, nice and simple. The MAPECU3 FCD can be wired in the same way and you set the clamp voltage to 4.3V. There is a clamp release pressure too...
    5 replies | 81 view(s)
  • MAP-ECU Man's Avatar
    22nd-August-2019, 11:03 AM
    MAP-ECU Man replied to a thread 98 Aristo MAF intercept in Tables
    You have to have the ignition setting match your wiring, i.e. COP if it is COP and wasted spark if it is wasted spark. The consequence of having it...
    3 replies | 488 view(s)
  • MAP-ECU Man's Avatar
    22nd-August-2019, 10:56 AM
    MAP-ECU Man replied to a thread Fuel Cut question in Technical
    You can probably use the FCD function with the benefit of overboost safety function. How is the boost cut module wired into the vehicle?
    5 replies | 81 view(s)
  • MAP-ECU Man's Avatar
    19th-August-2019, 08:06 PM
    MAP-ECU Man replied to a thread injector sizing in Technical
    I didn’t believe even e85 will cause you to use double the fuel volume so I think 2150cc is too big. You might want to consider using the flex fuel...
    5 replies | 89 view(s)
  • MAP-ECU Man's Avatar
    19th-August-2019, 09:55 AM
    MAP-ECU Man replied to a thread injector sizing in Technical
    Good question. Yes, that guideline is for regular gas. You need more fuel when running e85 so you can go bigger again. Just be aware of the...
    5 replies | 89 view(s)
  • MAP-ECU Man's Avatar
    19th-August-2019, 09:54 AM
    Yes, that's what the different pressure sensor selections do. The only problem is that if you have a tuned table setup for the other pressure scale...
    3 replies | 63 view(s)
  • MAP-ECU Man's Avatar
    19th-August-2019, 09:48 AM
    MAP-ECU Man replied to a thread Launch control? in Technical
    How about retarding the LC ignition timing. Have you tired that?
    3 replies | 71 view(s)
No More Results
About MAP-ECU Man

Basic Information

Signature


MAP-ECU Support

Statistics


Total Posts
Total Posts
6,588
Posts Per Day
1.42
General Information
Last Activity
5th-September-2019 04:31 PM
Join Date
24th-December-2006
Referrals
8