Results 1 to 3 of 3

Thread: 1995 GS300 -> Aristo 2JZ-GTE (MKIII Supra injectors)

  1. Default 1995 GS300 -> Aristo 2JZ-GTE (MKIII Supra injectors)

    Ok, so I hooked up my 1995 GS300 with a new motor. (out of a 1995 Toyota Aristo JDM 2JZ-GTE)

    MKIII 440cc low impedance resistance injectors instead of the stock 440cc high impedance. (I used a resistor pack).

    Loaded up the MKIV Supra JDM Map, ditched the Stock MAP sensor, set the idle and full throttle settings, and bumped the key.

    Perfectly clean start in 2 seconds, to a 1200rpm idle, dropping to a perfect 850 idle 15 seconds later. Everything worked perfectly the first time. Now I can START putting the darned car back together 8-). It's only been a friggin year since I started this project.

    notes for (people who may be searching for these info):
    1995 Aristo JDM ECU, MKIII Supra 440cc low impedance injectors (with installed resistor pack), ditched stock MAP sensor, used stock Air intake Temp Sensor.


  2. #2

    Default fuel map

    Hey whats up,where u got ur startup map from?I have a similar setup.

  3. #3


    Jeff is referring to the 2JZ-GTE JDM base table on the website and supplied on the MAP-ECU CDROM.
    MAP-ECU Support

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts