Results 1 to 2 of 2

Thread: Map/Maf 0-5V output connection for AEM water methanol injection

  1. #1

    Default Map/Maf 0-5V output connection for AEM water methanol injection

    Hi Mapecu man,

    AEM water methanol injection kit required an Map/Maf output of 0-5V for their controller to control the injection setting, can I tapped AEM Map input signal into the Green wire on mapecu1 for the voltage output for AEM to read boost target?

    thank you for your time,

    Tim

  2. #2

    Default

    Hi Tim, yes, no problem. As far as the water/meth unit is concerned, the MAF Output green wire is the vehicles MAF signal.
    MAP-ECU Support

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •